# Apparent power: VA, kVA and MVA ratings

> Rescale apparent power without treating it as real power or energy.

- Tool: [Apparent power Converter](https://toolsg.com/en/apparent-power-converter)
- Language: en (available: en, zh, ms, ta)
- Last verified against official sources: 2026-10-18
- Source site: ToolSG — a planning guide, not official or financial advice. Cite the agencies listed under Sources.

## Key figures at a glance

| Fact | Value | Source |
| --- | --- | --- |
| Kilovolt-ampere | 1 kVA = 1000 VA | [NIST](https://www.nist.gov/pml/special-publication-811/nist-guide-si-chapter-4-two-classes-si-units-and-si-prefixes) |
| Megavolt-ampere | 1 MVA = 1000000 VA | [NIST](https://www.nist.gov/pml/special-publication-811/nist-guide-si-chapter-4-two-classes-si-units-and-si-prefixes) |

## Read the rating as apparent power

Select the source and target unit and enter a decimal value. The browser shows the equivalent rating and all-unit table to six significant digits. The converter changes the prefix only; it does not measure a circuit or size equipment.

## VA and watts answer different questions

In a single-phase circuit, apparent power is RMS voltage multiplied by RMS current. Real power in watts also depends on the power factor: P = S × power factor. Therefore a VA rating cannot be relabelled as watts without more information. This tool has no power-factor input.

## Worked examples

Examples use the actual unit engine and configured decimal multipliers.

| Input | Result |
| --- | --- |
| 2.5 kVA | 2500 VA |
| 0.8 MVA | 800 kVA |
| 500 VA | 0.5 kVA |

## A rating is not energy consumption

VA describes apparent power, not watt-hours or running time. Nameplate ratings, operating measurements and circuit conditions can differ. The tool does not account for phases, starting current or load limits. Use the [power converter](https://toolsg.com/en/power-converter) for real-power units, the [reactive power converter](https://toolsg.com/en/reactive-power-converter) for var and the [energy converter](https://toolsg.com/en/energy-converter) for energy.

## Frequently asked questions

**How accurate are the results?**

Conversions use exact factors where an exact factor exists, and standard published values otherwise. Results are shown to six significant digits, which is more precision than almost any practical measurement warrants.

**Is anything sent to a server?**

No. The conversion runs entirely in your browser. Nothing you type is uploaded, logged or stored.

**Why does the table skip some units?**

A unit is omitted when the conversion has no finite result. In the pace converter, zero speed has no finite pace and zero pace has no finite speed.

**Can I convert several units at once?**

Yes. The table under the converter shows your value in every unit of this dimension simultaneously, so you can read off whichever you need.


## Sources

- [Schneider Electric — Definition of Power Factor](https://www.electrical-installation.org/enwiki/Definition_of_Power_Factor)
- [NIST — SI Units and Prefixes](https://www.nist.gov/pml/special-publication-811/nist-guide-si-chapter-4-two-classes-si-units-and-si-prefixes)
- [PNNL — Power and Energy Units in CIM](https://pnnl-cim-tools.github.io/CIM-Graph/02_cim_profiles/2_5_using_units/)
