# Area conversion for floor plans and land measurements

> Convert square metres, square feet, acres and hectares while keeping area separate from length.

- Tool: [Area Converter](https://toolsg.com/en/area-converter)
- Language: en (available: en, zh, ms, ta)
- Last verified against official sources: 2026-10-18
- Source site: ToolSG — a planning guide, not official or financial advice. Cite the agencies listed under Sources.

## Key figures at a glance

| Fact | Value | Source |
| --- | --- | --- |
| Square foot | 1 ft² = 0.09290304 m² | [NIST](https://www.nist.gov/pml/us-surveyfoot/revised-unit-conversion-factors) |
| Acre | 1 ac = 4046.8564224 m² | [NIST](https://www.nist.gov/pml/us-surveyfoot/revised-unit-conversion-factors) |
| Hectare | 1 ha = 10000 m² | [NIST](https://www.nist.gov/pml/special-publication-811/nist-guide-si-chapter-5-units-outside-si) |

## Choose the measurement you actually have

Select the source and destination area units, then enter a decimal value. The result and the table of equivalent values update in your browser. Swap reverses the selected units. The separate reference table describes one unit of the default source, rather than your current input.

## Why the length factor must be squared

Area conversion uses squared lengths: 1 ft = 0.3048 m, so 1 ft² = 0.3048 × 0.3048 m². Multiplying a floor area by the length factor alone gives the wrong result. To measure a rectangle, first put both side lengths in the same unit, then multiply them.

## Worked examples

The table uses the configured conversion factors. The converter displays six significant digits; ≈ marks rounded values.

| Input | Result |
| --- | --- |
| 100 m² | ≈ 1076.39 ft² |
| 1 ac | ≈ 0.404686 ha |
| 10000 cm² | 1 m² |

## Property measurements and limits

These factors use the international foot. Check the convention before converting historical survey records. Converting units does not reconcile different definitions of usable, gross or advertised floor area. It also does not add precision to an approximate measurement. For side lengths use the [length converter](https://toolsg.com/en/length-converter).

## Frequently asked questions

**How accurate are the results?**

Conversions use exact factors where an exact factor exists, and standard published values otherwise. Results are shown to six significant digits, which is more precision than almost any practical measurement warrants.

**Is anything sent to a server?**

No. The conversion runs entirely in your browser. Nothing you type is uploaded, logged or stored.

**Why does the table skip some units?**

A unit is omitted when the conversion has no finite result. In the pace converter, zero speed has no finite pace and zero pace has no finite speed.

**Can I convert several units at once?**

Yes. The table under the converter shows your value in every unit of this dimension simultaneously, so you can read off whichever you need.


## Sources

- [NIST — Revised Unit Conversion Factors](https://www.nist.gov/pml/us-surveyfoot/revised-unit-conversion-factors)
- [NIST — Units Outside the SI](https://www.nist.gov/pml/special-publication-811/nist-guide-si-chapter-5-units-outside-si)
