# Illuminance conversion: lux, foot-candles and light on a surface

> Translate incident-light measurements without treating lumens or watts as lux.

- Tool: [Illuminance Converter](https://toolsg.com/en/illuminance-converter)
- Language: en (available: en, zh, ms, ta)
- Last verified against official sources: 2026-10-18
- Source site: ToolSG — a planning guide, not official or financial advice. Cite the agencies listed under Sources.

## Key figures at a glance

| Fact | Value | Source |
| --- | --- | --- |
| Kilolux | 1 klx = 1000 lx | [NIST](https://www.nist.gov/pml/special-publication-811/nist-guide-si-chapter-4-two-classes-si-units-and-si-prefixes) |
| Foot-candle | 1 fc ≈ 10.7639 lx | [NIST](https://www.nist.gov/pml/special-publication-811/nist-guide-si-appendix-b-conversion-factors/nist-guide-si-appendix-b9) |
| Phot | 1 ph = 10000 lx | [NIST](https://www.nist.gov/pml/special-publication-811/nist-guide-si-appendix-b-conversion-factors/nist-guide-si-appendix-b9) |

## Convert a surface measurement

Choose the source and destination illuminance units and enter the value. The browser calculates the result and all-unit table to six significant digits. The converter does not read a camera or light sensor; it needs a measurement supplied by you.

## Lux, lumens and watts differ

Illuminance describes luminous flux arriving per area: one lux is one lumen per square metre. Lumens describe luminous flux, while watts describe power. Neither a lamp's lumen rating nor its electrical wattage alone determines lux at a desk.

## Worked examples

Examples use the actual engine and configured factors; ≈ marks rounding.

| Input | Result |
| --- | --- |
| 500 lx | ≈ 46.4515 fc |
| 1 klx | 1000 lx |
| 0.02 ph | 200 lx |

## Measurement conditions matter

Distance, aiming, light distribution and the measurement plane affect a reading. Unit conversion does not estimate these effects or certify lighting adequacy. Compare measurements taken under the same conditions. For surface sizes use the [area converter](https://toolsg.com/en/area-converter); for electrical power use the [power converter](https://toolsg.com/en/power-converter).

## Frequently asked questions

**How accurate are the results?**

Conversions use exact factors where an exact factor exists, and standard published values otherwise. Results are shown to six significant digits, which is more precision than almost any practical measurement warrants.

**Is anything sent to a server?**

No. The conversion runs entirely in your browser. Nothing you type is uploaded, logged or stored.

**Why does the table skip some units?**

A unit is omitted when the conversion has no finite result. In the pace converter, zero speed has no finite pace and zero pace has no finite speed.

**Can I convert several units at once?**

Yes. The table under the converter shows your value in every unit of this dimension simultaneously, so you can read off whichever you need.


## Sources

- [NIST — SI Units and Prefixes](https://www.nist.gov/pml/special-publication-811/nist-guide-si-chapter-4-two-classes-si-units-and-si-prefixes)
- [NIST — Unit Conversion Factors](https://www.nist.gov/pml/special-publication-811/nist-guide-si-appendix-b-conversion-factors/nist-guide-si-appendix-b9)
