# Pressure conversion: pascals, bar, atmospheres and psi

> Convert pressure units while keeping the measurement reference unchanged.

- Tool: [Pressure Converter](https://toolsg.com/en/pressure-converter)
- Language: en (available: en, zh, ms, ta)
- Last verified against official sources: 2026-10-18
- Source site: ToolSG — a planning guide, not official or financial advice. Cite the agencies listed under Sources.

## Key figures at a glance

| Fact | Value | Source |
| --- | --- | --- |
| Bar | 1 bar = 100000 Pa | [NIST](https://www.nist.gov/pml/special-publication-811/nist-guide-si-appendix-b-conversion-factors/nist-guide-si-appendix-b9) |
| Standard atmosphere | 1 atm = 101325 Pa | [NIST](https://www.nist.gov/pml/special-publication-811/nist-guide-si-appendix-b-conversion-factors/nist-guide-si-appendix-b9) |
| Pound-force per square inch | 1 psi ≈ 6894.76 Pa | [NIST](https://www.nist.gov/pml/special-publication-811/nist-guide-si-appendix-b-conversion-factors/nist-guide-si-appendix-b9) |

## Choose the units

Select the source and destination pressure units, enter the number and read the result or equivalent-unit table. The calculations run locally and results use six significant digits. Swap reverses the pair; it does not change what the measurement means.

## Pressure is force per area

The pascal is one newton per square metre. A standard atmosphere is a defined unit, not today's local air pressure. Bar and atmosphere are close in size but are not equal. The converter uses stored reference factors for mercury-column units; it does not simulate a physical manometer.

## Worked examples

These examples are calculated by the actual engine; ≈ indicates a rounded result.

| Input | Result |
| --- | --- |
| 1 bar | 100 kPa |
| 1 atm | 1.01325 bar |
| 35 psi | ≈ 241.317 kPa |

## Gauge versus absolute

Gauge pressure is measured relative to a reference, commonly ambient pressure; absolute pressure is referenced to vacuum. Changing psi to kPa does not turn gauge pressure into absolute pressure. That requires the reference pressure too. Preserve labels such as psig or psia from the source document. For weather conditions use the [weather monitor](https://toolsg.com/en/weather-monitor); for force turning an object use the [torque converter](https://toolsg.com/en/torque-converter), a different quantity.

## Frequently asked questions

**How accurate are the results?**

Conversions use exact factors where an exact factor exists, and standard published values otherwise. Results are shown to six significant digits, which is more precision than almost any practical measurement warrants.

**Is anything sent to a server?**

No. The conversion runs entirely in your browser. Nothing you type is uploaded, logged or stored.

**Why does the table skip some units?**

A unit is omitted when the conversion has no finite result. In the pace converter, zero speed has no finite pace and zero pace has no finite speed.

**Can I convert several units at once?**

Yes. The table under the converter shows your value in every unit of this dimension simultaneously, so you can read off whichever you need.


## Sources

- [NIST — Pressure Calibration in Gauge and Absolute Modes](https://nvlpubs.nist.gov/nistpubs/Legacy/SP/nistspecialpublication250-39e2009.pdf)
- [NIST — Pressure and Stress Conversion Factors](https://www.nist.gov/pml/special-publication-811/nist-guide-si-appendix-b-conversion-factors/nist-guide-si-appendix-b9)
